What a knitting fault looks like in the finished garment
Short answer: Most knitting flaws show up as a vertical line, a horizontal stripe or a small hole. Each type points to its own cause in the machine. With a little knowledge you can tell whether it is a flaw or just the normal look of the fabric.
Vertical line
A broken or worn needle makes a thin line down through the fabric, because the same loop is missing in every row. It is clearest against the light and can be hard to spot in dark colours. Such a line often runs the whole length of the fabric, so it shows across the garment.
Horizontal stripe
If the yarn tension or the lot changes along the way, a row of loops becomes larger or slightly different in colour. That gives a stripe across. It shows best in plain fabric and can run right round the garment. See bamboo sweatpants for women if you want to look at plain pieces.
Small holes
A knot in the yarn or a kink can leave a hole the size of a pinhead. It is the most common rejection criterion in quality control. A small hole can hide in a seam, but it can also sit in the middle of the surface, where it is clearly seen. See bamboo tops for women.
Ladders and pulled threads
A ladder appears when a thread is pulled out and the loops run like rungs. A pulled thread makes a small loop on the surface. Both can come from production or from wear, for instance from jewellery or a zip, so it matters to see when it happened.
How to check a new garment
Hold the garment up to daylight and look at both the right side and the wrong side. Look for lines, stripes and holes, especially on large plain areas. Do it when you receive the garment, so you can raise a claim quickly if something is not as it should be.
Are all flaws caught at the factory
No. The fabric is inspected, but small flaws can slip through in large lots. Quality control is about finding most, not all, and each check rests on what an eye can see in a short time. So a single garment can have a flaw even if the rest of the lot is fine.
Can a small hole be repaired
Yes. Sew it together from the wrong side with thin thread before it grows. Use a needle with a round tip so you do not cut the loops, and make small stitches in the direction of the knit. If the hole is large or in a visible place, a tailor can help. See bamboo T-shirt for women.
How to document a flaw
Take a photo in daylight and show both the whole garment and a close-up of the flaw. Write where on the garment it sits and whether you have washed it. This makes it easier to judge whether the flaw comes from the knitting or from wear.
Is a stripe grounds for a complaint
If it is clear in normal daylight, yes. Write to customer service and attach a picture that shows the flaw. If it is only visible when you hold the garment very close or up to a bright lamp, it is often part of the fabric's normal look. Describe where and how it shows.
Frequently asked questions
Are all flaws caught at the factory
No. The fabric is inspected, but small flaws can slip through in large lots, because the check rests on what an eye can see.
Can a small hole be repaired
Yes. Sew it together from the wrong side with thin thread before it grows. If it is in a visible place, a tailor can help.
Is a stripe grounds for a complaint
If it is clear in normal daylight, yes. Write to customer service and attach a picture that clearly shows the flaw.
You can find the full range at Bamboo-Clothing.com.




