Skip to content
Shrinkage percentage and how it is measured

Shrinkage percentage and how it is measured

Short answer: Shrinkage is measured by drawing a square on the fabric, washing it by a fixed method and measuring again. The difference in percent is the shrinkage, and it is measured both lengthways and crossways. Here is how it works and what the figure tells you.

Marks that do not move

Three pairs of marks are placed in each direction at an exact distance. The marks are made to survive washing, and the distance is noted before the first treatment. After washing and drying the same marks are measured again, and the average is used as the result, so the figure rests on several measurements.

The method must be the same every time

Temperature, programme, detergent and drying method are set in a standard. Otherwise two laboratories cannot compare figures, and a result means little unless you know how it was measured. Shrinkage affects fit, for example in bamboo polos for men.

Lengthways and crossways

Shrinkage is measured in two directions, because fabric does not behave the same everywhere. In knit fabric the length usually shrinks most, because the loops pull together when the tension from production is released. The width may shrink less or even grow a little. A data sheet should list both figures.

What counts as acceptable

For knits, up to five percent is typically accepted, and less for woven fabric. If it goes above that, the factory adjusts the pattern or pre-treats the fabric more. The maker can also allow for shrinkage when drawing the pattern, so the finished garment fits after washing.

Why fabric shrinks

During production the fabric is pulled and held taut, and that tension sits in the fibres like a kind of memory. The first wash and heat release it, and the fabric pulls back towards its natural state. That is why new clothes often shrink most the first time and less afterwards.

How washing affects it

Higher temperatures and hard spinning usually cause more shrinkage than cool, gentle washing. A tumble dryer makes it quicker and clearer, especially on knits. Follow the care label and choose a low temperature if you want to keep the measurements. See also home and homewear in bamboo and Nordic Weaving.

Measuring at home

You can run a simple test of your own. Measure the garment before the first wash, for example from shoulder to hem and across the chest, and note the numbers. Wash and dry as usual, then measure the same places again. The difference divided by the first measurement and multiplied by one hundred is your shrinkage percentage.

A word of caution

Home measuring is rough, because the garment is not laid perfectly flat every time and because knit is soft and changes shape when pulled. Use it for a feel, not as a final answer. Laboratory figures are more precise, since the method is fixed and the conditions are always the same.

Getting the most from the figure

Use the shrinkage figure to judge whether the size will still fit after washing, and to compare two fabrics. Choose a size from the size chart rather than the letter, and read the care label. That way you avoid surprises and get clothes that fit after many washes.

Frequently asked questions

Can I measure shrinkage at home

Yes. Measure the garment before the first wash and again after drying, in the same place and the same way. The result is rough, but it gives a good feel for how the fabric behaves.

Does a garment shrink equally everywhere

No. The length usually shrinks most in knits, because the loops pull together. The width shrinks less, and sometimes the change is barely noticeable.

Can something shrink in width and grow in length

Yes. It happens when the fabric was stretched crossways during production. The change appears when the tension is released at the first wash.

You can find the full range at Bamboo-Clothing.com.

The products from this article

See all (Nordic Weaving)