The drawstring in the waist that disappears in the wash
Short answer: The drawstring disappears into the channel when the ends can slip through the hole. Tie a knot at each end and it will not happen again, and if it has already slipped in, you can get it out with a safety pin in a few minutes.
Why it happens
During washing, the drawstring is pulled around by water and other clothes in the drum, and if the ends are narrower than the hole, it slowly slides in. It happens most often at the first wash, before the drawstring has settled. The smoother the drawstring, the easier it slips into the channel.
A knot at each end
A simple knot at each end is enough. It is too thick to pass through the hole, so it stays put however much the trousers are thrown around in the machine. Pull the knot tight so it does not come loose, and leave a few centimetres of drawstring beyond it.
How to get it back out
Attach a safety pin to one end of the drawstring and close it. Push the pin into the hole and work it through the channel by gathering the fabric in front of the pin and smoothing it out behind. Keep going until the pin comes out of the other hole. It takes a few minutes.
Another method
If you have no safety pin, a drinking straw or a knitting needle can work instead, provided the channel is wide enough. Push the drawstring into the straw, or tape it to the needle, and guide it through the channel in the same way. A hairpin can also work in narrow channels.
Prevent it when washing
Tie the drawstring in a loose bow before washing, so it does not hang free and get pulled around the drum. Close any zips and turn the trousers inside out as well. The drawstring then moves less, and the fabric around the holes is not worn by the string rubbing against the edge.
Where it happens most
It happens most in soft trousers with a drawstring in a wide waistband, typically sweatpants and pyjama bottoms that are washed often. See bamboo sweatpants for men and bamboo pyjama bottoms for women, where the waistband and drawstring are part of the fit.
When the drawstring is worn
A drawstring with frayed ends slips in more easily, because the end gets thinner. Trim the loose threads and tie a new knot further up. If the drawstring is badly worn, it can be replaced with a ribbon or a new cord, which you thread in with a safety pin.
Drying
Let the trousers dry on a line with the drawstring loosely tied, so the waistband can settle in its own time. A tumble dryer can make the elastic shrink or lose its grip, and then the drawstring has to be pulled tighter to hold the trousers up, which wears both cord and holes.
See also
The drawstring is a small thing, but it is part of the wider care if the trousers are to last. Wash at 40 degrees, avoid fabric softener and let them dry in the air. The other care rules are collected in the washing guide.
A quick check
Make it a habit to check the drawstring when you put the trousers in the laundry basket. If both ends are knotted and the bow is tied, you can be fairly sure the drawstring will still be in place when you take the trousers out of the machine.
Frequently asked questions
How do I get the drawstring back?
Attach a safety pin to the end and work it through the channel by gathering the fabric in front of the pin. Keep going until it comes out of the other hole.
How do I avoid it in future?
Tie a knot at each end of the drawstring and tie it in a loose bow before washing. Then it can neither slip in nor be pulled around the drum.
Can you wash the trousers without tying the drawstring?
Yes, but the risk of losing the drawstring is greater. Knots at the ends take seconds and save you from threading it back in afterwards.
You can find the full range at Bamboo-Clothing.com.




