Skip to content

problemer

What you should know about clothes and moths

Short answer: Moth larvae eat protein fibres such as wool and silk. Bamboo viscose and cotton are cellulose and are m...

What you can do about clothes that have gone stiff

Short answer: Stiff fabric is caused by residue in the fibres, most often from detergent, fabric softener or lime. Tw...

What happens to clothes if you use too much detergent

Short answer: Excess detergent does not rinse out of the washing machine on its own. It stays in the fibres, makes th...

Bamboo clothing and what to do about a loose thread

Short answer: Never cut a loose thread on a knitted fabric. Pull it gently through to the inside with a needle, and t...

Bamboo clothing and how to stop it clinging

Short answer: Clothes cling either because of static electricity or because a light fabric settles close to the body....

Laundry that does not come clean and what causes it

Short answer: When laundry does not come out clean, one of four things is usually wrong. The machine is too full, the...

Bamboo towels and why they lose their absorbency

Short answer: A towel that does not absorb has developed a film on its fibres. Fabric softener is the most common cau...

Why clothes smell even after washing

Short answer: Either the smell is in the washing machine, or fabric softener and soap residue are trapping odours in ...

Bra straps that slip down and what to do about it

Short answer: Straps slip when they are too loose, when they sit too far out on the shoulder, or when the shoulders s...

Why the bra band rides up at the back

Short answer: The band rides up because it is too loose. The weight pulls forward and down, and a loose band gives wa...

Underwear and light clothing and what shows through

Short answer: Under light clothes, it is contrast that shows. Skin tone briefs disappear, white ones stand out, and d...

Briefs under tight trousers and how to avoid edges

Short answer: A visible line comes from elastic that is thicker than the fabric around it. The fix is a laser cut edg...